| Hardware Specifications |
| Copper Ports |
4 2.5GBASE-T RJ45 auto negotiation port
Supports 2.5G/1G/100/10Mbps data rate |
| SFP+ Ports |
2 10GBASE-SR/LR SFP+ slots
Backward compatible with 1000BASE-SX/LX/BX and 2500BASE-X SFP transceivers |
| PoE Injector Ports |
4 ports with 802.3bt PoE++ injector function, from Port-1 to Port-4 |
| Console |
1 x RJ45-to-RS232 serial port (115200, 8, N, 1) |
| Reset Button |
< 5 sec: System reboot
> 5 sec: Factory default |
| Connector |
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for Alarm, Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND |
| Alarm |
One relay output for power failure. Alarm relay current carry ability: 1A @ 24VDC |
| Digital Input (DI) |
2 digital inputs:
Level 0: -24~2.1V (±0.1V)
Level 1: 2.1~24V (±0.1V)
Input load to 24VDC, 10mA max. |
| Digital Output (DO) |
2 digital outputs:
Open collector to 24VDC, 100mA |
| Enclosure |
IP30 aluminum case |
| Installation |
DIN-rail or wall-mount |
| SDRAM |
512Mbytes |
| Flash Memory |
64Mbytes |
| Dimensions (W x D x H) |
76 x 135 x 152 mm |
| Weight |
1,319g |
| Power Requirements |
DC 48V-54V, 8.3A max. |
| Power Consumption |
48VDC Input:
Max. 8.9 watts/30.4 BTU (Idle)
Max. 379 watts/1293.2 BTU (Full load)
54VDC Input:
Max. 9.2 watts/31.4 BTU (Idle)
Max. 381 watts/1300 BTU (Full load) |
| ESD Protection |
Contact 4KVDC; Air 8KVDC |
| Surge Protection |
2KVDC |
| LED Indicators |
System:
Power 1 (Green), Power 2 (Green)
Alarm (Red)
Ring (Green), Ring Owner (Green)
DI/DO (Red)
PoE Usage:
120W/240W/360W (Amber)
Per 10/100/1G/2.5GBASE-T RJ45 Port:
Data LED:
1G/2.5G LNK/ACT (Green)
10/100 LNK/ACT (Amber)
PoE LED:
IEEE 802.3bt Mode (Green)
IEEE 802.3at Mode (Amber)
Per 1G/2.5G/10GBASE-X SFP+ Port:
1G/2.5Gbps LNK/ACT (Green)
10Gbps LNK/ACT (Amber) |
| Switching Specifications |
| Switch Architecture |
Store-and-Forward |
| Switch Fabric |
60Gbps/non-blocking |
| Throughput |
44.462Mpps@64Bytes |
| Address Table |
8K entries, automatic source address learning and aging |
| Shared Data Buffer |
32Mbits |
| Jumbo Frame |
10K bytes |
| Flow Control |
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex |
| Power over Ethernet |
| PoE Standard |
IEEE 802.3bt PoE++ Type-4 |
| PoE Power Supply Type |
End-span
Mid-span
BT |
| Power Pin Assignment |
802.3bt/UPoE: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
802.3at/PoE: End-span: 1/2(-), 3/6(+)
802.3at/PoE: Mid-span: 4/5(+), 7/8(-) |
| PoE Power Output |
Per port 48V ~ 54VDC
-802.3bt Type-4 mode: maximum 95 watts
-End-span mode: maximum 36 watts
-Mid-span mode: maximum 36 watts
-Force mode: maximum 95 watts |
| PoE Power Budget |
Single power input: 240W maximum (depending on power input)
Dual power input: 360W maximum (depending on power input)
※Dual power input must be the same as DC voltage, like dual 54V. |
| Number of 90W 802.3bt Type-4 PDs |
4 |
| Number of 60W 802.3bt Type-3 PDs |
4 |
| Number of 30W 802.3at Type-2 PDs |
4 |
| PoE Management Functions |
| Enhanced PoE Mode |
Standard/Legacy/Force |
| PoE Management |
PD Alive Check
Scheduled Power Recycling
PoE Schedule
PoE Usage Monitoring
PoE Extension |
| Active PoE Device Live Detection |
Yes |
| PoE Power Recycling |
Yes, daily or predefined schedule |
| PoE Schedule |
4 schedule profiles |
| PoE Extend Mode |
Yes, max. up to 160 meters |
| Layer 3 Functions |
| IP Interfaces |
Max. 32 VLAN interfaces |
| Routing Table |
Max. 32 static routing entries
Max. 1K routing table entries |
| Routing Protocols |
IPv4 RIPv2
IPv4 OSPFv2
IPv6 OSPFv3
IPv4 hardware static routing
IPv6 hardware static routing |
| Layer 2 Functions |
| Port Configuration |
Port disable/enable
Auto-negotiation 10/100/1000/2500Mbps full and half duplex mode selection
Flow control disable/enable
Port link capability control |
| Port Status |
Display of each port’s speed duplex mode, link status, flow control status, auto-negotiation status and trunk status |
| Port Mirroring |
TX/RX/Both
Many-to-1 monitor
RMirror – Remote Switched Port Analyzer (Cisco RSPAN)
Supports up to 5 sessions |
| VLAN |
IEEE 802.1Q tagged VLAN
IEEE 802.1ad Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
IP Subnet-based VLAN
MVR (Multicast VLAN registration)
GVRP
Up to 4K VLAN groups, out of 4095 VLAN IDs |
| Link Aggregation |
IEEE 802.3ad LACP/static trunk
Max. 3 trunk groups with max. 6 ports per trunk group |
| Spanning Tree Protocol |
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
Supports 7 MSTP instances
BPDU Guard, BPDU filtering and BPDU transparent
Root Guard |
| IGMP Snooping |
IPv4 IGMP (v1/v2/v3) snooping
IPv4 IGMP querier mode support
Supports 255 IGMP groups |
| MLD Snooping |
IPv6 MLD (v1/v2) snooping,
IPv6 MLD querier mode support
Supports 255 MLD groups |
| Bandwidth Control |
Per port bandwidth control
Ingress: 10Kbps~13128Mbps
Egress: 10Kbps~13128Mbps |
| Ring |
Supports ERPS, and complies with ITU-T G.8032
Recovery time < 10ms @ 3 nodes
Recovery time < 50ms @ 16 nodes
Supports Major ring and sub-ring |
| Synchronization |
IEEE 1588v2 PTP (Precision Time Protocol)
Peer-to-peer transparent clock
End-to-end transparent clock |
| QoS |
Traffic classification based, strict priority and WRR
8-level priority for switching:
Port number
802.1p priority
802.1Q VLAN tag
DSCP/ToS field in IP packet |
| Security Functions |
| Access Control List |
IP-based ACL/MAC-based ACL
ACL based on:
MAC Address
IP Address
Ethertype
Protocol Type
VLAN ID
DSCP
802.1p Priority
Up to 512 entries |
| Security |
Port security
IP source guard, up to 512 entries
Dynamic ARP inspection, up to 1K entries
Command line authority control based on user level
Static MAC address, up to 64 entries |
| AAA |
RADIUS client
TACACS+ client |
| Network Access Control |
IEEE 802.1x port-based network access control
MAC-based authentication
Local/RADIUS authentication |
| Management |
| Basic Management Interfaces |
Console; Telnet; Web browser; SNMP v1, v2c |
| Secure Management Interfaces |
SSHv2, TLS v1.2, SNMPv3 |
| System Management |
Firmware upgrade by HTTP protocol through Ethernet network
Configuration upload/download through HTTP
Remote Syslog
System log
LLDP protocol
NTP
PLANET Smart Discovery Utility
PLANET CloudViewer app |
| SNMP MIBs |
RFC 1213 MIB-II
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
RFC 2863 Interface MIB
RFC 2665 Ether-Like MIB
RFC 2819 RMON MIB (Group 1, 2, 3 and 9)
RFC 2737 Entity MIB
RFC 2618 RADIUS Client MIB
RFC 2863 IF-MIB
RFC 2933 IGMP-STD-MIB
RFC 3411 SNMP-Frameworks-MIB
RFC 4292 IP Forward MIB
RFC 4293 IP MIB
RFC 4836 MAU-MIB
IEEE 802.1X PAE
LLDP |
| Standards Conformance |
| Regulatory Compliance |
FCC Part 15 Class A
CE:
EN55032
EN55035 |
| Stability Testing |
IEC60068-2-32 (free fall)
IEC60068-2-27 (shock)
IEC60068-2-6 (vibration) |
| Standards Compliance |
IEEE 802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE 802.3ae 10GBASE-X
IEEE 802.3bz 2.5/5GBASE-T
IEEE 802.3x flow control and back pressure
IEEE 802.3ad port trunk with LACP
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE 802.1X Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3ah OAM
IEEE 802.1ag Connectivity Fault Management (CFM)
RFC 768 UDP
RFC 783 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2
RFC 3376 IGMP v3
RFC 2710 MLD v1
RFC 3810 MLD v2
RFC 2328 OSPF v2
RFC 5340 OSPF v3
RFC 2453 RIP v2
ITU-T G.8032 ERPS Ring |
| Environment |
| Operating |
-40 ~ 75 degrees C |
| Storage |
-40 ~ 85 degrees C |
| Humidity |
5 ~ 95% (non-condensing) |
Site Map
Contact Us
RSS