| Hardware Specifications |
| Copper Ports |
8 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
| SFP Fiber Ports |
2 100/1000BASE-X SFP interfaces (Port 9 and Port 10)
2 100/1000/2500BASE-X SFP interfaces (Port 11 and Port 12) |
| PoE Injector Ports |
8 ports with 802.3at/af PoE injector function (Ports 1 to 8) |
| Console |
1 x RJ45-to-RS232 serial port (115200, 8, N, 1) |
| RAM |
128MBytes |
| Flash Memory |
64MBytes |
| Reset Button |
< 5 sec: System reboot
> 5 sec: Factory default |
| ESD Protection |
6KV DC |
| Enclosure |
IP30 aluminum case |
| Installation |
DIN-rail kit and wall-mount kit |
| Connector |
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND |
| Alarm |
One relay output for power failure. Alarm relay current carry ability: 1A @ 24V DC |
| Digital Input |
2 digital input (DI)
Level 0: -24V~2.1V (±0.1V)
Level 1: 2.1V~24V (±0.1V)
Input load to 24V DC, 10mA max. |
| Digital Output |
2 digital output(DO)
Open collector to 24VDC, 100mA max. |
| Dimensions (W x D x H) |
76.8 x 107.3 x 152mm |
| Weight |
1128g |
| Power Requirements |
Dual 12~54V DC |
| Power Consumption |
Max. 7.28 watts/22.11BTU (Power on without any connection)
Max.249 watts/849.09BTU (Full loading with PoE function) |
| LED Indicator |
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm (Red)
Ring (Green)
Ring Owner (Green)
DIDO (Red)
Per 10/100/1000T RJ45 PoE+ Ports:
PoE-in-Use (Amber)
LNK/ACT (Green)
Per 10/100/1000T RJ45Ports:
1000 LNK/ACT (Green)
100 LNK/ACT (Amber)
Per SFP Interface:
100 LNK/ACT (Amber)
1G/2.5G LNK/ACT (Green) |
| Switching |
| Switch Architecture |
Store-and-Forward |
| Switch Fabric |
30Gbps/non-blocking |
| Throughput (packet per second) |
22.32Mpps@ 64 bytes packet |
| Address Table |
8K entries, automatic source address learning and aging |
| Shared Data Buffer |
4Mbits |
| Flow Control |
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex |
| Jumbo Frame |
9Kbytes |
| Power Over Ethernet |
| PoE Standard |
IEEE 802.3at Power over Ethernet Plus/PSE
Backward compatible with 802.3af Power over Ethernet |
| PoE Power Supply Type |
End-span |
| PoE Power Output |
IEEE 802.3at Standard
Per port 52V~54V DC, max. 36 watts |
| Power Pin Assignment |
1/2(+), 3/6(-) |
| PoE Power Budget |
60W maximum (DC 12V power input)
120W maximum (DC 24V power input)
240W maximum (DC 48V ~ 54V power input) |
| Max. Number of Class 2 PDs |
8 |
| Max. Number of Class 3 PDs |
8 |
| Max. Number of Class 4 PDs |
8 |
| PoE Management Functions |
| Active PoE device alive detection |
Yes |
| PoE Power Recycling |
Yes, daily or predeinded schedule |
| PoE Schedule |
4 schedule profiles |
| PoE Extend Mode |
Yes, max. 160 to 200 meters |
| PoE System Management |
System PoE Admin control
Total PoE power budget control
PoE Legacy mode
Over-temperature threshold alarm
PoE usage threshold alarm |
| PoE Port Management |
Port Enable/Disable/Schedule
Port Priority |
| Layer 3 Functions |
| IP Interfaces |
Max. 8 VLAN interfaces |
| Routing Table |
Max. 32 routing entries |
| Routing Protocols |
IPv4 software static routing
IPv6 software static routing |
| Layer 2 Functions |
| Port Configuration |
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Power saving mode control |
| Port Status |
Display each port’s speed duplex mode, link status, flow control status,
auto negotiation status, trunk status |
| Port Mirroring |
TX / RX / Both
Many-to-1 monitor |
| VLAN |
IEEE 802.1Q tag-based VLAN
IEEE 802.1ad Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
VLAN Translation
Voice VLAN
MVR (Multicast VLAN Registration)
GVRP
Up to 4K VLAN groups, out of 4094 VLAN IDs |
| Link Aggregation |
IEEE 802.3ad LACP/static trunk
Supports 6 trunk groups with 4 ports per trunk group |
| Spanning Tree Protocol |
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol |
| IGMP Snooping |
IPv4 IGMP (v1/v2/v3) snooping
IPv4 IGMP querier mode support
Up to 255 multicast groups |
| MLD Snooping |
IPv6 MLD (v1/v2/v3) snooping
IPv6 MLD querier mode support
Up to 255 multicast groups |
| Bandwidth Control |
Per port bandwidth control
Ingress: 500Kb~1000Mbps
Egress: 500Kb~1000Mbps |
| RING |
Supports ERPS, and complies with ITU-T G.8032
Recovery time < 10ms |
| Synchronization |
IEEE 1588v2 PTP(Precision Time Protocol)
Peer-to-peer transparent clock
End-to-end transparent clock |
| QoS |
Traffic classification based, strict priority and WRR
8-level priority for switching
Port number
802.1p priority
802.1Q VLAN tag
DSCP/TOS field in IP packet |
| Security Functions |
| Access Control List |
IP-based ACL/MAC-based ACL
ACL based on:
MAC Address
IP Address
Ethertype
Protocol Type
VLAN ID
DSCP
802.1p Priority
Up to 256 entries |
| Security |
Port Security
IP source guard
Dynamic ARP inspection
Command line authority control based on user level |
| AAA |
RADIUS client
TACACS+ client |
| Network Access Control |
IEEE 802.1x port-based network access control
MAC-based authentication
Local/RADIUS authentication |
| Switch Management |
| Basic Management Interfaces |
Console;Telnet; Web browser; SNMP v1, v2c |
| Secure Management Interfaces |
SSHv2, TLSv1.2, SNMPv3 |
| System Management |
Firmware upgrade by HTTP protocol through Ethernet network
Configuration upload/download through HTTP
Remote syslog
System log
LLDP protocol
NTP
PLANET Smart Discovery Utility |
| Event Management |
Remote syslog
Local system log
SMTP |
| ONVIF |
ONVIF device discovery
ONVIF device monitoring
Floor Map |
| SNMP MIBs |
RFC1213 MIB-II
RFC 2863 IF-MIB
RFC1643 Ethernet MIB
RFC2863 Interface MIB
RFC2665 Ether-Like MIB
RFC2737 Entity MIB
RFC2819 RMON MIB (Groups 1, 2, 3 and 9)
RFC2618 RADIUS Client MIB
RFC3411SNMP-Frameworks-MIB
IEEE802.1X PAE
LLDP
MAU-MIB
Power over Ethernet MIB |
| Standards Conformance |
| Regulatory Compliance |
FCC Part 15 Class A, CE |
| Stability Testing |
IEC60068-2-32 (free fall)
IEC60068-2-27 (shock)
IEC60068-2-6 (vibration) |
| Standards Compliance |
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-TX/100BASE-FX
IEEE802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE802.3x flow control and back pressure
IEEE802.3ad port trunk with LACP
IEEE802.1D Spanning Tree Protocol
IEEE802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE802.1p Class of Service
IEEE802.1Q VLAN tagging
IEEE 802.1ad Q-in-Q VLAN stacking
IEEE 802.1X Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
IEEE 802.3ah OAM
IEEE 1588 PTPv2
RFC 768 UDP
RFC 793 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2
RFC 3376 IGMP version 3
RFC 2710 MLD version 1
RFC 3810 MLD version 2
ITU-T G.8032 ERPS Ring |
| Environment |
| Operating Temperature |
-40 ~ 75 degrees C |
| Storage Temperature |
-40 ~ 85 degrees C |
| Humidity |
5 ~ 95% (non-condensing) |
Site Map
Contact Us
RSS