| Hardware Specifications |
| Copper Ports |
8 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
| SFP Slots |
2 100/1000/2500BASE-X SFP interfaces
Compatible with 100BASE-FX, 1000BASE-SX/LX/BX and 2500BASE-X SFP transceivers |
| PoE Injector Port |
8 ports with 802.3bt PoE++ injector function with Port-1 to Port-8 |
| RAM |
128MBytes |
| Flash Memory |
64MBytes |
| Reset Button |
< 5 sec: System reboot
> 5 sec: Factory Default |
| Connector |
4-pin terminal block for power input
- Pin 1/2 for Power 1 (Pin 1: V+ / Pin 2: V-)
- Pin 3/4 for Power 2 (Pin 3: V+ / Pin 4: V-)
2-pin terminal block for event alarm |
| Alarm |
One relay output for power failure. Alarm Relay current carry ability: 1A @ 24V DC |
| Enclosure |
IP30 aluminum case |
| Installation |
Wall-mount |
| Dimensions (W x D x H) |
245 x 36 x 140 mm |
| Weight |
1,299g |
| Power Requirements |
48~54V DC (>52V DC for PoE++ and PoE+ output recommended)
Dual power input is required for maximum power loading |
| Power Consumption |
Max. 14.72 watts/50.23 7BTU@50V DC input (Power on without any connection)
Max. 375 watts/1280BTU@Single 54V DC input (Full loading with 360 watts PoE function)
Max. 752 watts/2566BTU@Dual 54V DC input (Full loading with 720 watts PoE function) |
| ESD Protection |
6KV DC |
| LED Indicator |
System:
- PWR 1(Green)
- PWR 2 (Green)
- Ring (Green)
- Ring Owner (Green)
Per 10/100/1000T RJ45 PoE++ Ports:
- 802.3bt PoE-in-Use (Green)
- 802.3af/at PoE-in-Use (Amber)
- 1000 LNK/ACT (Green)
- 10/100 LNK/ACT (Amber)
Per SFP Interface:
- 100 LNK/ACT (Amber)
- 1000/2500 LNK/ACT (Green) |
| Switching Specifications |
| Switch Architecture |
Store-and-Forward |
| Switch Fabric |
26Gbps/non-blocking |
| Throughput (packet per second) |
19.345Mpps@ 64 bytes packet |
| Address Table |
8K entries, automatic source address learning and aging |
| Shared Data Buffer |
4Mbits |
| Flow Control |
IEEE 802.3x pause frame for full duplex
Back pressure for half duplex |
| Jumbo Frame |
9Kbytes |
| Power Over Ethernet |
| PoE Standard |
IEEE 802.3bt PoE++ Type-4 PSE
Backward compatible with 802.3at PoE+ PSE |
| PoE Power Supply Type |
- 802.3bt
- UPOE/POH
- End-span
- Mid-span
- Force |
| PoE Power Output |
802.3bt PoE++
- Per port 52V~56V DC (depending on the power supply), max. 90 watts
UPoE(PoH)
- Per port 52V~56V DC (depending on the power supply), max. 95 watts
IEEE 802.3at Standard
- Per port 52V~56V DC (depending on the power supply), max. 36 watts
Force
- Per port 52V~56V DC (depending on the power supply), max. 60 watts |
| Power Pin Assignment |
End-span: 1/2 (-), 3/6 (+)
Mid-span: 4/5 (+), 7/8 (-)
802.3bt/UPoE: 1/2 (-), 3/6 (+),4/5 (+), 7/8 (-) |
| PoE Power Budget |
48V Power input
- 125W maximum (depending on power input)
52~54V Power input
- Single power input: 360W maximum (depending on power input)
- Dual power input: 720W maximum (depending on power input)
※Dual power input must be the same as DC voltage, like dual 54V |
| Max. number of Class 3 PDs |
8 |
| Max. number of Class 4 PDs |
8 |
| Max. number of Class 8 PDs |
8 |
| PoE Management Functions |
| Active PoE device alive detects |
Yes |
| PoE Power Recycle |
Yes, daily or predeinded schedule |
| PoE Schedule |
4 schedule profiles |
| PoE Extend Mode |
Yes, max. 160 to 200 meters |
| PoE System Management |
System PoE Admin control
Total PoE power budget control
Auto power input and PoE budget control
PoE Legacy mode
Over-temperature threshold alarm
PoE usage threshold alarm |
| PoE Port Management |
Port Enable/Disable/Schedule
PoE mode control
- 802.3bt
- UPoE
- 802.3at End-span
- 802.3at Mid-span
- Force mode
Port Priority |
| Layer 3 Functions |
| IP Interfaces |
Max. 8 VLAN interfaces |
| Routing Table |
Max. 32 routing entries |
| Routing Protocols |
Ipv4 software static routing
Ipv6 software static routing |
| Layer 2 Function |
| Port Configuration |
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable
Port link capability control |
| Port Status |
Display each port’s speed duplex mode, link status, flow control status,
auto negotiation status, trunk status |
| Port Mirroring |
TX/RX/both
Many-to-1 monitor |
| VLAN |
IEEE 802.1Q tag-based VLAN
IEEE 802.1ad Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
MVR (Multicast VLAN Registration)
GVRP
Up to 4K VLAN groups, out of 4094 VLAN IDs |
| Link Aggregation |
IEEE 802.3ad LACP/static trunk
Supports 2 trunk groups with 2 ports per trunk group |
| Spanning Tree Protocol |
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol |
| IGMP Snooping |
Ipv4 IGMP (v1/v2 /v3) Snooping
Ipv4 IGMP Querier mode support
Up to 255 multicast Groups |
| MLD Snooping |
Ipv6 MLD (v1/v2) Snooping
Ipv6 MLD Querier mode support
Up to 255 multicast Groups |
| Bandwidth Control |
Per port bandwidth control
Ingress: 500Kb~1000Mbps
Egress: 500Kb~1000Mbps |
| RING |
Supports ERPS, and complies with ITU-T G.8032
Recovery time < 10ms |
| Synchronization |
IEEE 1588v2 PTP(Precision Time Protocol)
- Peer-to-peer transparent clock
- End-to-end transparent clock |
| QoS |
Traffic classification based, strict priority and WRR
8-level priority for switching
- Port number
- 802.1p priority
- 802.1Q VLAN tag
- DSCP/TOS field in IP packet |
| Security Functions |
| Access Control List |
IP-based ACL/MAC-based ACL
ACL based on:
- MAC Address
- IP Address
- Ethertype
- Protocol Type
- VLAN ID
- DSCP
- 802.1p Priority
Up to 256 entries |
| Security |
Port security
IP source guard
Dynamic ARP inspection
Command line authority control based on user level |
| AAA |
RADIUS client
TACACS+ client |
| Network Access Control |
IEEE 802.1x port-based network access control
MAC-based authentication
Local/RADIUS authentication |
| Management Functions |
| Basic Management Interfaces |
Telnet; Web browser; SNMP v1, v2c |
| Secure Management Interfaces |
SSHv2, TLS v1.2, SNMPv3 |
| System Management |
Firmware upgrade by HTTP protocol through Ethernet network
Configuration upload/download through HTTP
LLDP protocol
NTP
PLANET Smart Discovery Utility |
| Event Management |
Remote Syslog
System log
SMTP |
| ONVIF |
ONVIF device discovery
ONVIF device monitoring
Floor Map |
| SNMP MIBs |
RFC 1213 MIB-II
IF-MIB
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
RFC 2863 Interface MIB
RFC 2665 Ether-Like MIB
RFC 2819 RMON MIB (Groups 1, 2, 3 and 9)
RFC 2737 Entity MIB
RFC 2618 RADIUS Client MIB
RFC 2933 IGMP-STD-MIB
RFC 3411 SNMP-Frameworks-MIB
IEEE 802.1X PAE
LLDP
MAU-MIB
Power over Ethernet MIB |
| Standards Conformance |
| Regulatory Compliance |
FCC Part 15 Class A, CE |
| Stability Testing |
IEC60068-2-32 (free fall)
IEC60068-2-27 (shock)
IEC60068-2-6 (vibration) |
| Standards Compliance |
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX/100BASE-FX
IEEE 802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE 802.3x flow control and back pressure
IEEE 802.3ad port trunk with LACP
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE 802.1X Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3ah OAM
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
IEEE 802.3bt Power over Ethernet Plus Plus
RFC 768 UDP
RFC 793 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2
RFC 3367 IGMP version 3
RFC 2710 MLD version 1
RFC 3810 MLD version 2
ITU-T G.8032 Ethernet Ring Protection Switching |
| Environment |
| Operating Temperature |
-20 ~ 70 degrees C |
| Storage Temperature |
-40 ~ 85 degrees C |
| Humidity |
5 ~ 95% (non-condensing) |
Site Map
Contact Us
RSS