| Wireless Transmission |
| Technology |
LoRaWAN |
| Frequency |
LS200-MK8-868M
863–870 MHz
LS200-MF8-915M
902–928 MHz |
| TX Power |
LS200-MK8-868M
EU868 16dBm
IN865 20dBm (optional)
LS200-MF8-915M
US915 20dBm
AS923 16dBm (optional)
AU915 20dBm (optional)
KR920 14dBm (optional) |
| Rx Sensitivity |
-136dBm (LoRa, Spreading Factor = 12, Bitrate = 293bps)
-121dBm (FSK, Frequency Deviation = 5kHz, Bitrate = 1.2kbps) |
| Work Mode |
OTAA/ABP Class A |
| Data Interfaces |
| Power Supply |
2x 3.0V CR2450 button battery (Battery not included) |
| Operating Voltage |
DC 2.3 ~ 3V |
| Battery Life Time |
2.26 years
(25°C, 60-minute reports, TxPower=20dBm, SF10) |
| Low Battery Threshold |
3.2V |
| Physical Characteristics |
| Dimensions (L x W x H) |
75.5 x 19.4 x 44 mm |
| Weight |
120 g |
| Sensor Dimensions |
Reed Switch: 46 x 16 x 12.9mm
Glass Break Sensor: 36 x 36 x 7.9mm |
| Ingress Protection |
IP30
Reed switch - IP67
glass break - IP40 |
| Sensor Measurements |
Temperature Sensor Information
Measurement Range: -20°C to 55°C
Measurement Accuracy: ±1°C
Humidity Sensor Information
Measurement Range: 0% RH to 100% RH
Measurement Accuracy: ±7%RH
Passive Infrared Sensor Information
Detectable Angle: 80° horizontally / 55° vertically
Detectable Range: 3m to 5m
Light Sensor Information
Illumination Measurement Range: 1 Lux to 3000 Lux
Illumination Measurement Accuracy: <15%
Tilt Sensor Information
Conversion Angle: 45±5 degrees
Contact Resistance: Less than 10 ohms
The Insulation Resistance: Greater than 100 megohms
Operating Temperature: -40°C to 85 °C
Installation Type: Suitable for PCB at vertical state
Vibration Sensor Information
Model: Ball type omnidirectional signal trigger switch
Voltage: <6V
Current: 2uA to 10mA
Insulation Resistance: >10M Ω
Trigger Rate: 100% (amplitude > 1 mm, frequency > 20 Hz)
Trigger Frequency: >50Hz
Reed Switch Sensor Information
Minimum Insulation Resistance 10^10 Ω
Maximum Contact Resistance 100m Ω
Maximum Switching Current 0.5A
Glass Break Sensor Information
Detection Mode: Piezoelectric buzzer
Power Supply: Self-generated voltage chip
Impedance: Normal (NC): 7Ω (max) Alarm (NO): 1MΩ (min)
Sensor Sensing Range: within 2.5M radius
Signal Sensing Time: 1-3 seconds
Loop Voltage: 15VDC (max)
Loop Current: 25mA (max)
Operating Temperature: -10 to 50 °C
Wire Length: 100cm |
| Operating Temperature |
-10°C to 50°C |
| Relative Humidity |
<90% RH (non-condensing) |
| Storage Temperature |
-40 °C ~ 85 °C |
| Standards Conformance |
| Regulatory Compliance |
CE RED, FCC PART 15B |